SIMPLY IT Gets Conditional Pass on Health Inspection - Chicago Restaurant

SANITIZING RINSE FOR EQUIPMENT AND UTENSILS: CLEAN, PROPER TEMPERATURE, CONCENTRATION, EXPOSURE TIME - Comments: Equipment and utensils should get proper exposure to the sanitizing solution during the rinse cycle. Bactericidal treatment shall consist of exposure of all dish and utensil surfaces to a rinse of clean water at a temperature of not less than 180F. CHEMICAL DISH MACHINE NOT PROPERLY SANITIZING WHILE DISHES ARE BEING WASHED. FOUND CHEMICAL DISH MACHINE WITH DISPENSING 0PPM CHLORINE SANITIZER AFTER SEVERAL ATTEMPTS. MACHINE TAGGED HELD FOR INSPECTION AND MUST NOT USE UNTIL SANITIZING TO 100PPM AND SUPERVISOR SALAZAR CONTACTED AT 312-746-5426.

Improper sanitization fails to kill pathogens, allowing contaminated equipment to spread illness throughout facility.

Sanitizing solutions and rinse water must meet specific requirements for effectiveness.

Chemical sanitizers: Chlorine 50-100 ppm, Quaternary ammonium 200-400 ppm, Iodine 12.5-25 ppm; Hot water: 171°F for 30 seconds or 180°F at dish surface; Test strips required; Proper contact time.

FOOD IN ORIGINAL CONTAINER, PROPERLY LABELED: CUSTOMER ADVISORY POSTED AS NEEDED - Comments: All food not stored in the original container shall be stored in properly labeled containers. ALL BULK FOOD CONTAINERS MUST BE LABELED.

Improper methods result in slow cooling that allows bacterial growth.

Approved cooling methods must be used.

Use shallow pans, ice baths, rapid chill units, ice wands; Cut large items into smaller portions; Stir frequently; Leave uncovered during cooling.

CLEAN MULTI-USE UTENSILS AND SINGLE SERVICE ARTICLES PROPERLY STORED: NO REUSE OF SINGLE SERVICE ARTICLES - Comments: Containers and utensils shall be inverted, covered, or otherwise protected from contamination until used. All single-service drinking straws and containers shall be discarded immediately after use. TABLEWARES MUST BE COVERED OR WRAPPED. KNIVES STORED IMPROPERLY BETWEEN PREP TABLES AND ELECTRICAL CONDUITS. MUST PROVIDE PROPER HOLDER. CLEAN UTENSILS STORED HANGING ABOVE EXPOSED HAND SINK, MUST REMOVE AND STORE PROPERLY.

Consumers need warning about increased risk from raw/undercooked foods.

Required consumer advisories for raw/undercooked foods.

Disclosure and reminder for raw/undercooked animal foods; Written notice on menu; Must identify specific items.

FOOD AND NON-FOOD CONTACT SURFACES PROPERLY DESIGNED, CONSTRUCTED AND MAINTAINED - Comments: All food and non-food contact equipment and utensils shall be smooth, easily cleanable, and durable, and shall be in good repair. MUST NOT USE TINFOIL AS LINER FOR EQUIPMENT.

Unapproved processes may lack critical safety controls.

Variance required before conducting specialized food processes.

Submit application to CDPH; Include HACCP plan; Await approval before starting; Maintain all required records.

FOOD AND NON-FOOD CONTACT EQUIPMENT UTENSILS CLEAN, FREE OF ABRASIVE DETERGENTS - Comments: All food and non-food contact surfaces of equipment and all food storage utensils shall be thoroughly cleaned and sanitized daily. ALL BULK FOOD CONTAINERS MUST CLEAN. MUST CLEAN EXTERIOR ALL COOKING EQUIPMENT. VENTILATION HOOD WITH EXCESSIVE GREASE DRIPPING, MUST CLEAN.

Dirty equipment harbors bacteria and attracts pests.

All equipment and utensils must be clean and properly maintained.

Equipment clean to sight and touch; Free of food debris and grease; Maintained in good repair; Stored properly when clean.

FLOORS: CONSTRUCTED PER CODE, CLEANED, GOOD REPAIR, COVING INSTALLED, DUST-LESS CLEANING METHODS USED - Comments: The floors shall be constructed per code, be smooth and easily cleaned, and be kept clean and in good repair. ALL STORED ARTICLES THROUGHOUT MUST BE STORED ELEVATED FROM FLOOR, INCLUDING GARAGE STORAGE. FLOORS UNDER ALL COOKS LINE EQUIPMENT DIRTY WITH GREASE AND DEBRIS, MUST CLEAN AND MAINTAIN.

Damaged floors harbor bacteria and create safety hazards.

Floors must be smooth, cleanable, and maintained.

Smooth, non-porous in food areas; Properly sloped to drains; Coving at wall junctures; Kept clean; Good repair.

WALLS, CEILINGS, ATTACHED EQUIPMENT CONSTRUCTED PER CODE: GOOD REPAIR, SURFACES CLEAN AND DUST-LESS CLEANING METHODS - Comments: The walls and ceilings shall be in good repair and easily cleaned. WALL CAULKING AT THREE COMPARTMENT SINK MOLDY IN POOR REPAIR, MUST REPLACE.

Damaged surfaces cannot be properly cleaned and may harbor pests.

Walls and ceilings must be smooth, cleanable, and in good repair.

Smooth, washable surfaces in food areas; Light colored; No holes or cracks; Clean and maintained.

LIGHTING: REQUIRED MINIMUM FOOT-CANDLES OF LIGHT PROVIDED, FIXTURES SHIELDED - Comments: Shielding to protect against broken glass falling into food shall be provided for all artificial lighting sources in preparation, service, and display facilities. DIRTY LIGHT SHIELD ABOVE ENTRANCE TO WALK IN COOLER WITH DEAD INSECTS, MUST CLEAN.

Inadequate lighting prevents detection of contamination and pests.

Adequate protected lighting required in all areas.

50 foot-candles at prep surfaces; 20 foot-candles at 30 inches in storage; Shielded bulbs over exposed food; Clean fixtures.

LIGHTING: REQUIRED MINIMUM FOOT-CANDLES OF LIGHT PROVIDED, FIXTURES SHIELDED - Comments: Shielding to protect against broken glass falling into food shall be provided for all artificial lighting sources in preparation, service, and display facilities. DIRTY LIGHT SHIELD ABOVE ENTRANCE TO WALK IN COOLER WITH DEAD INSECTS, MUST CLEAN.

Inadequate lighting prevents detection of contamination and pests.

Adequate protected lighting required in all areas.

50 foot-candles at prep surfaces; 20 foot-candles at 30 inches in storage; Shielded bulbs over exposed food; Clean fixtures.