NEW JB-ONE Gets Conditional Pass on Health Inspection - Chicago Restaurant

PERSON IN CHARGE PRESENT, DEMONSTRATES KNOWLEDGE, AND PERFORMS DUTIES - Comments: OBSERVED NO PERSON IN CHARGE DURING INSPECTION. INSTRUCTED MANAGER TO DESIGNATE PERSON IN CHARGE DURING ALL HOURS OF OPERATION. PRIORITY FOUNDATION

Without knowledgeable supervision, critical food safety practices may be overlooked, significantly increasing risk of foodborne illness outbreaks affecting multiple customers.

The person in charge must be present during all hours of operation, hold valid certification, and demonstrate food safety knowledge.

Person in charge must: Be present during all operating hours; Hold valid City of Chicago Food Service Sanitation Certificate; Demonstrate knowledge of foodborne disease prevention, HACCP principles, and Code requirements; Ensure employee compliance with food safety practices.

CITY OF CHICAGO FOOD SERVICE SANITATION CERTIFICATE - Comments: OBSERVED NO CHICAGO FOOD SANITATION MANAGER ON SITE AND VALID CERTIFICATE POSTED. A CERTIFIED MANAGER MUST BE ON SITE AND VALID CERTIFICATE POSTED AT ALL TIMES TCS FOOD PREPARED AND SERVED. PRIORITY FOUNDATION 7-38-012

Lack of certification indicates potential gaps in food safety knowledge, increasing risk of improper food handling and foodborne illness.

Valid City of Chicago Food Service Sanitation Certificate required and must be posted.

Certificate must be: Current and valid; Posted conspicuously in public view; Held by person in charge during all operating hours; Renewed before expiration date.

ADEQUATE HANDWASHING SINKS PROPERLY SUPPLIED AND ACCESSIBLE - Comments: OBSERVED NO PAPER TOWELS AT HAND WASHING SINK IN WASHROOM. INSTRUCTED MANAGER TO PROVIDE FOR HAND DRYING. PRIORITY FOUNDATION 7-38-030)C)

Blocked or unsupplied sinks force employees to skip handwashing, spreading fecal bacteria and viruses to food.

Handwashing sinks must be accessible, properly supplied, and used only for handwashing.

Each sink needs: Warm water (100°F minimum); Soap in dispensers; Paper towels or air dryers; Waste receptacles; Signage; Clear access; Used only for handwashing.

PROPER COLD HOLDING TEMPERATURES - Comments: OBSERVED SOUR CREAM 52.7F AND SLICED TOMATOES 52.3F STORED AT IMPROPER TEMPERATURE IN PREP COOLER. INSTRUCTED MANAGER TO DISCARD. ALL COLD TCS FOOD MUST MAINTAIN 41F OR BELOW DURING STORAGE, PREPARATION, DISPLAY AND SERVICE. PRIORITY FOUNDATION 7-38-005

Temperatures below 135°F allow bacteria to multiply, especially spore-formers that survive cooking.

Hot foods must be held at 135°F or above.

Maintain 135°F or above; Check temperatures regularly; Proper hot holding equipment; Cannot reheat in hot holding units.

FOOD & NON-FOOD CONTACT SURFACES CLEANABLE, PROPERLY DESIGNED, CONSTRUCTED & USED - Comments: OBSERVED SOILED CARDBOARD ON SHELVING UNITS IN REAR STORAGE AREA. INSTRUCTED MANAGER TO REMOVE.

Poor design creates areas that harbor bacteria.

All surfaces must be designed to be easily cleanable.

Smooth, non-porous surfaces; Free of cracks and crevices; Easily disassembled; Accessible for cleaning.

NON-FOOD/FOOD CONTACT SURFACES CLEAN - Comments: OBSERVED ACCUMULATED SPILLAGE AND DEBRIS INSIDE REACH-IN AND PREP COOLERS. INSTRUCTED MANAGER TO CLEAN AND MAINTAIN.

Accumulated soil attracts pests and harbors bacteria.

All surfaces must be kept clean.

Clean equipment interiors and exteriors; Walls, ceilings, floors clean; Remove grease and debris; Clean as often as necessary.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: OBSERVED NO BACK FLOW DEVICE ON UTILITY SINK. INSTRUCTED MANAGER TO PROVIDE BACK FLOW DEVICE ON UTILITY SINK.

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: OBSERVED NO BACK FLOW DEVICE ON UTILITY SINK. INSTRUCTED MANAGER TO PROVIDE BACK FLOW DEVICE ON UTILITY SINK.

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.