JW MARRIOTT HOTEL CHICAGO Gets Conditional Pass on Health Inspection - Chicago Restaurant

HANDS CLEAN & PROPERLY WASHED - Comments: OBSERVED FOOD EMPLOYEE IN THE ROOM SERVICE STATION IMPROPERLY WASHED HANDS BY ONLY RINSING AND DRYING. INSTRUCTED MANAGER THAT EMPLOYEES MUST USE HAND WASHING SOAP AND PROPERLY WASH THEIR HANDS AND EXPOSED PORTIONS OF ARMS FOR AT LEAST 20 SECONDS. PRIORITY VIOLATION, 7-38-010. CITATION ISSUED.

Improper sanitization fails to kill pathogens, allowing contaminated equipment to spread illness throughout facility.

Sanitizing solutions and rinse water must meet specific requirements for effectiveness.

Chemical sanitizers: Chlorine 50-100 ppm, Quaternary ammonium 200-400 ppm, Iodine 12.5-25 ppm; Hot water: 171°F for 30 seconds or 180°F at dish surface; Test strips required; Proper contact time.

ADEQUATE HANDWASHING SINKS PROPERLY SUPPLIED AND ACCESSIBLE - Comments: OBSERVED NO HAND WASHING SIGNAGE FOR THE HAND WASHING SINKS IN THE LOBBY BAR. INSTRUCTED TO PROVIDE.

Blocked or unsupplied sinks force employees to skip handwashing, spreading fecal bacteria and viruses to food.

Handwashing sinks must be accessible, properly supplied, and used only for handwashing.

Each sink needs: Warm water (100°F minimum); Soap in dispensers; Paper towels or air dryers; Waste receptacles; Signage; Clear access; Used only for handwashing.

ADEQUATE HANDWASHING SINKS PROPERLY SUPPLIED AND ACCESSIBLE - Comments: OBSERVED NO PAPER TOWELS AT THE HAND WASHING SINKS IN THE LOBBY BAR. INSTRUCTED MANAGEMENT THAT ALL HANDWASHING SINKS MUST BE EQUIPPED WITH A HAND DRYING PROVISION AT ALL TIMES. MANAGER PROVIDED DURING INSPECTION. PRIORITY FOUNDATION 7-38-030(C). CITATION ISSUED.

Blocked or unsupplied sinks force employees to skip handwashing, spreading fecal bacteria and viruses to food.

Handwashing sinks must be accessible, properly supplied, and used only for handwashing.

Each sink needs: Warm water (100°F minimum); Soap in dispensers; Paper towels or air dryers; Waste receptacles; Signage; Clear access; Used only for handwashing.

WIPING CLOTHS: PROPERLY USED & STORED - Comments: OBSERVED WET WIPING CLOTHS STORED ON THE PREP TABLES AND ON HANDWASHING SINKS IN THE PASTRY AND DISH WASHING AREA. INSTRUCTED TO KEEP WIPE CLOTHS STORED IN PROPER SANITIZING SOLUTION WHEN NOT IN USE.

Contaminated cloths spread bacteria across multiple surfaces.

Wiping cloths must be properly sanitized and stored.

Store in sanitizer between uses (200ppm quat or 50-100ppm chlorine); Separate cloths for food and non-food surfaces; Test sanitizer concentration.

FOOD & NON-FOOD CONTACT SURFACES CLEANABLE, PROPERLY DESIGNED, CONSTRUCTED & USED - Comments: OBSERVED CUTTING BOARDS WITH OPEN SEAMS AND DARK STAINS IN THE ROOM SERVICE STATION. MUST REFINISH OR REPLACE DAMAGED OR STAINED CUTTING BOARDS.

Poor design creates areas that harbor bacteria.

All surfaces must be designed to be easily cleanable.

Smooth, non-porous surfaces; Free of cracks and crevices; Easily disassembled; Accessible for cleaning.

NON-FOOD/FOOD CONTACT SURFACES CLEAN - Comments: MUST CLEAN DUST ACCUMULATION FROM COOLER VENTILATION SYSTEMS AND GREASE BUILD UP FROM COOKING EQUIPMENT IN THE ROOM SERVICE STATION.

Accumulated soil attracts pests and harbors bacteria.

All surfaces must be kept clean.

Clean equipment interiors and exteriors; Walls, ceilings, floors clean; Remove grease and debris; Clean as often as necessary.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: OBSERVED A LEAKING PIPE UNDER THREE COMPARTMENT SINK IN THE DISH WASHING AREA. INSTRUCTED TO REPAIR AND MAINTAIN.

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: OBSERVED A LEAKING PIPE UNDER THREE COMPARTMENT SINK IN THE DISH WASHING AREA. INSTRUCTED TO REPAIR AND MAINTAIN.

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.