THE SOCIETY FOR THE DANISH OLD PEOPLE'S HOME Fails Health Inspection - Chicago Long term care

MANAGEMENT, FOOD EMPLOYEE AND CONDITIONAL EMPLOYEE; KNOWLEDGE, RESPONSIBILITIES AND REPORTING - Comments: OBSERVED NO WRITTEN EMPLOYEE HEALTH POLICY ON THE PREMISES. MANAGEMENT INSTRUCTED TO PROVIDE A SIGNED EMPLOYEE HEALTH POLICY FOR EACH EMPLOYEE. PRIORITY FOUNDATION 7-38-010,NO CITATION ISSUED.

Ill food workers cause 70% of foodborne outbreaks. Proper reporting prevents transmission of Norovirus, Hepatitis A, Salmonella, and other serious diseases.

All food employees must understand and follow health reporting requirements and food safety responsibilities.

Employees must: Report illness symptoms and exposures; Be excluded/restricted when ill; Understand their role in preventing foodborne illness; Follow proper hygiene practices; Have signed health policy on file.

PROCEDURES FOR RESPONDING TO VOMITING AND DIARRHEAL EVENTS - Comments: OBSERVED NO CLEAN UP PROCEDURE ON THE PREMISES FOR VOMIT AND DIARRHEAL EVENTS. MANAGEMENT INSTRUCTED TO PROVIDE A CLEAN UP PROCEDURE AND SUPPLIES. PRIORITY FOUNDATION 7-38-005, NO CITATION ISSUED.

Vomit and diarrhea contain millions of viral particles. One incident can contaminate entire facility and cause outbreak affecting dozens.

Written procedures required for cleaning bodily fluid events to prevent disease transmission.

Written procedure must address: Isolating contaminated area; Removing and discarding affected food; Using proper PPE; Cleaning and sanitizing with appropriate concentration; Proper disposal of contaminated materials.

FOOD-CONTACT SURFACES: CLEANED & SANITIZED - Comments: OBSERVED BLACK SLIMY SUBSTANCES ON INTERIOR WATER COMPONENTS OF THE ICE MACHINE,DRIPPING INTO ICE "ICE IS USED FOR HUMAN CONSUMPTION". MANAGEMENT WAS INSTRUCTED TO TURN OFF MACHINE, REMOVE ICE AND HAVE INTERIOR OF ICE MACHINE CLEANED AND SANITIZED AND MAINTAIN. PRIORITY FOUNDATION VIOLATION 7-38-005,CITATION ISSUED.

Dirty equipment harbors and spreads pathogens, causing cross-contamination and illness.

All food contact surfaces must be properly cleaned and sanitized.

Wash, rinse, sanitize after each use; Clean between different raw foods; Every 4 hours for continuous use; When contaminated; Proper procedures and chemicals.

PROPER DATE MARKING AND DISPOSITION - Comments: OBSERVED READY-TO-EAT, TCS FOODS SUCH AS (PASTA,SALMON) NOT DATE MARKED TO INDICATED THE DATE IN WHICH THE FOOD MUST BE CONSUMED OR DISCARDED. FOOD MUST BE DISCARDED WITHIN 7 DAYS AFTER THE DATE IT WAS PREPARED, WITH THE DATE OF PREPARATION COUNTING AS DAY 1. PRIORITY FOUNDATION 7-38-005,NO CITATION ISSUED.

Inadequate reheating fails to kill bacteria that grew during storage.

Foods must be reheated to 165°F within 2 hours.

Reheat to 165°F within 2 hours; Use proper equipment (not hot holding units); Discard if not reaching temperature in time.

FOOD & NON-FOOD CONTACT SURFACES CLEANABLE, PROPERLY DESIGNED, CONSTRUCTED & USED - Comments: INSTRUCTED TO REPLACE WORNED-OUT WHITE CUTTING BOARDS STORED UNDERNEATH THE FOOD PREP TABLE AND TO MAINTAIN.

Poor design creates areas that harbor bacteria.

All surfaces must be designed to be easily cleanable.

Smooth, non-porous surfaces; Free of cracks and crevices; Easily disassembled; Accessible for cleaning.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: BACKFLOW PREVENTER NOT LOCATED AT ICE MACHINE AND COFFEE BREWER STATION IN FOOD PREP AREA.INSTRUCTED TO INSTALL SO THAT IT CAN BE LOCATED TO BE SERVICED AND MAINTAINED.

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: BACKFLOW PREVENTER NOT LOCATED AT ICE MACHINE AND COFFEE BREWER STATION IN FOOD PREP AREA.INSTRUCTED TO INSTALL SO THAT IT CAN BE LOCATED TO BE SERVICED AND MAINTAINED.

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.