RIVERS Gets Conditional Pass on Health Inspection - Chicago Restaurant

SANITIZING RINSE FOR EQUIPMENT AND UTENSILS: CLEAN, PROPER TEMPERATURE, CONCENTRATION, EXPOSURE TIME - Comments: Equipment and utensils should get proper exposure to the sanitizing solution during the rinse cycle. Bactericidal treatment shall consist of exposure of all dish and utensil surfaces to a rinse of clean water at a temperature of not less than 180F. Low temp glassware dishmachine at the bar was not sanitizing while being used by bar staff during inspection. Chlorine sanitizer was reading 0-ppm. Instd to use 3-comp sink or high temp dishmachine in dishroom until machine is fixed,

Improper sanitization fails to kill pathogens, allowing contaminated equipment to spread illness throughout facility.

Sanitizing solutions and rinse water must meet specific requirements for effectiveness.

Chemical sanitizers: Chlorine 50-100 ppm, Quaternary ammonium 200-400 ppm, Iodine 12.5-25 ppm; Hot water: 171°F for 30 seconds or 180°F at dish surface; Test strips required; Proper contact time.

FOOD AND NON-FOOD CONTACT SURFACES PROPERLY DESIGNED, CONSTRUCTED AND MAINTAINED - Comments: All food and non-food contact equipment and utensils shall be smooth, easily cleanable, and durable, and shall be in good repair. Must replace cooler door gaskets that are in poor repair at service line & at coffee station.

Unapproved processes may lack critical safety controls.

Variance required before conducting specialized food processes.

Submit application to CDPH; Include HACCP plan; Await approval before starting; Maintain all required records.

FOOD AND NON-FOOD CONTACT EQUIPMENT UTENSILS CLEAN, FREE OF ABRASIVE DETERGENTS - Comments: All food and non-food contact surfaces of equipment and all food storage utensils shall be thoroughly cleaned and sanitized daily. Following need cleaning: interior floors of most coolers, gaskets of cooler doors, fan guards of coolers, interior bottom of fryers, interior of ice machine, exterior sides of equipment- due to grease/dust/food debris.

Dirty equipment harbors bacteria and attracts pests.

All equipment and utensils must be clean and properly maintained.

Equipment clean to sight and touch; Free of food debris and grease; Maintained in good repair; Stored properly when clean.

FLOORS: CONSTRUCTED PER CODE, CLEANED, GOOD REPAIR, COVING INSTALLED, DUST-LESS CLEANING METHODS USED - Comments: The floors shall be constructed per code, be smooth and easily cleaned, and be kept clean and in good repair. Floors inside walk-in cooler need cleaning; some drains at main kitchen must be cleaned also.

Damaged floors harbor bacteria and create safety hazards.

Floors must be smooth, cleanable, and maintained.

Smooth, non-porous in food areas; Properly sloped to drains; Coving at wall junctures; Kept clean; Good repair.

FLOORS: CONSTRUCTED PER CODE, CLEANED, GOOD REPAIR, COVING INSTALLED, DUST-LESS CLEANING METHODS USED - Comments: The floors shall be constructed per code, be smooth and easily cleaned, and be kept clean and in good repair. Floors inside walk-in cooler need cleaning; some drains at main kitchen must be cleaned also.

Damaged floors harbor bacteria and create safety hazards.

Floors must be smooth, cleanable, and maintained.

Smooth, non-porous in food areas; Properly sloped to drains; Coving at wall junctures; Kept clean; Good repair.