PIZZA HUT Gets Conditional Pass on Health Inspection - Chicago Restaurant

SANITIZING RINSE FOR EQUIPMENT AND UTENSILS: CLEAN, PROPER TEMPERATURE, CONCENTRATION, EXPOSURE TIME - Comments: NO RESIDUAL ON DISHES AFTER BEING WASHED IN LOW TEMP DISH MACHINE - UNIT TAGGED HELD FOR INSPECTION - INSTRUCTED TO WASH, RINSE AND SANITIZE ALL MULTI-USE EQUIPMENT IN 3 COMP. SINK - CITATION ISSUED -CRITICAL

Improper sanitization fails to kill pathogens, allowing contaminated equipment to spread illness throughout facility.

Sanitizing solutions and rinse water must meet specific requirements for effectiveness.

Chemical sanitizers: Chlorine 50-100 ppm, Quaternary ammonium 200-400 ppm, Iodine 12.5-25 ppm; Hot water: 171°F for 30 seconds or 180°F at dish surface; Test strips required; Proper contact time.

* CERTIFIED FOOD MANAGER ON SITE WHEN POTENTIALLY HAZARDOUS FOODS ARE PREPARED AND SERVED - Comments: NO CERTIFIED MGR. ON PREMISES AT TIME OF INVESTIGATION - CITATION ISSUED - SERIOUS

Temperatures above 41°F allow rapid bacterial multiplication, doubling every 20 minutes.

Cold foods must be held at 41°F or below.

Maintain 41°F or below; Check temperatures regularly; Properly functioning refrigeration; Thermometers in all units; Keep doors closed.

FOOD AND NON-FOOD CONTACT SURFACES PROPERLY DESIGNED, CONSTRUCTED AND MAINTAINED - Comments: REMOVE RUSTY DEPOSITS FROM CAN OPENER BASE ON PREP.

Unapproved processes may lack critical safety controls.

Variance required before conducting specialized food processes.

Submit application to CDPH; Include HACCP plan; Await approval before starting; Maintain all required records.

FOOD AND NON-FOOD CONTACT EQUIPMENT UTENSILS CLEAN, FREE OF ABRASIVE DETERGENTS - Comments: CLEAN INTERIOR AND EXTERIOR SURFACES OF ALL DEEP FRYERS, HOODS & FILTERS, COOLERS AND FREEZERS.

Dirty equipment harbors bacteria and attracts pests.

All equipment and utensils must be clean and properly maintained.

Equipment clean to sight and touch; Free of food debris and grease; Maintained in good repair; Stored properly when clean.

FLOORS: CONSTRUCTED PER CODE, CLEANED, GOOD REPAIR, COVING INSTALLED, DUST-LESS CLEANING METHODS USED - Comments: DETAIL CLEAN FLOORS ALONG ALL WALL BASES, UNDERNEATH AND BEHIND ALL HEAVY EQUIPMENT THROUGHOUT.

Damaged floors harbor bacteria and create safety hazards.

Floors must be smooth, cleanable, and maintained.

Smooth, non-porous in food areas; Properly sloped to drains; Coving at wall junctures; Kept clean; Good repair.

WALLS, CEILINGS, ATTACHED EQUIPMENT CONSTRUCTED PER CODE: GOOD REPAIR, SURFACES CLEAN AND DUST-LESS CLEANING METHODS - Comments: PAINT RUSTY CEILING VENT IN WASHROOM. PAINT RUSTY DOOR FRAME TON WASHROOM. CLEAN WALLS, CEILING VENTS AND DOORS WHERE NEEDED. CLEAN INTERIORS OF COOLERS AND FREEZERS.

Damaged surfaces cannot be properly cleaned and may harbor pests.

Walls and ceilings must be smooth, cleanable, and in good repair.

Smooth, washable surfaces in food areas; Light colored; No holes or cracks; Clean and maintained.

WALLS, CEILINGS, ATTACHED EQUIPMENT CONSTRUCTED PER CODE: GOOD REPAIR, SURFACES CLEAN AND DUST-LESS CLEANING METHODS - Comments: PAINT RUSTY CEILING VENT IN WASHROOM. PAINT RUSTY DOOR FRAME TON WASHROOM. CLEAN WALLS, CEILING VENTS AND DOORS WHERE NEEDED. CLEAN INTERIORS OF COOLERS AND FREEZERS.

Damaged surfaces cannot be properly cleaned and may harbor pests.

Walls and ceilings must be smooth, cleanable, and in good repair.

Smooth, washable surfaces in food areas; Light colored; No holes or cracks; Clean and maintained.