PIZZA CAPRI Fails Health Inspection - Chicago Restaurant

SANITIZING RINSE FOR EQUIPMENT AND UTENSILS: CLEAN, PROPER TEMPERATURE, CONCENTRATION, EXPOSURE TIME - Comments: HIGH TEMPERATURE DISH MACHINE NOT ADEQUATELY SANITIZING FOOD EQUIPMENT AND UTENSILS FINAL RINSE 150F. INSTRUCTED MANAGER TO REPAIR DISH MACHINE AND MAINTAIN FINAL RINSE AT 180F. HIGH TEMPERATURE DISH MACHINE IS TAGGED HELD FOR INSPECTION AND MUST NOT BE USED UNTIL REINSPECTED BY CHICAGO DEPARTMENT OF HEALTH. CRITICAL VIOLATION 7-38-030

Improper sanitization fails to kill pathogens, allowing contaminated equipment to spread illness throughout facility.

Sanitizing solutions and rinse water must meet specific requirements for effectiveness.

Chemical sanitizers: Chlorine 50-100 ppm, Quaternary ammonium 200-400 ppm, Iodine 12.5-25 ppm; Hot water: 171°F for 30 seconds or 180°F at dish surface; Test strips required; Proper contact time.

NO EVIDENCE OF RODENT OR INSECT OUTER OPENINGS PROTECTED/RODENT PROOFED, A WRITTEN LOG SHALL BE MAINTAINED AVAILABLE TO THE INSPECTORS - Comments: OBSERVED OVER 20 FLYING INSECTS IN FRONT PREP, MIDDLE PREP, BASEMENT PREP DISH WASHING, AND DINING AREAS. INSTRUCTED MANAGER TO CALL AN EXTERMINATOR FOR SERVICE, CLEAN AND SANITIZE ALL AREAS. SERIOUS VIOLATION 7-38-020

Unprotected openings allow pest entry, leading to contamination of food and surfaces.

Building openings must be protected against pest entry.

Doors tight-fitting and self-closing; Windows screened; Openings sealed; Pest control log maintained; Regular monitoring; Professional service when needed.

FOOD IN ORIGINAL CONTAINER, PROPERLY LABELED: CUSTOMER ADVISORY POSTED AS NEEDED - Comments: LABEL ALL BULK CONTAINERS IN BASEMENT PREP AREA AND PREPARED FOOD IN WALK-IN COOLERS.

Improper methods result in slow cooling that allows bacterial growth.

Approved cooling methods must be used.

Use shallow pans, ice baths, rapid chill units, ice wands; Cut large items into smaller portions; Stir frequently; Leave uncovered during cooling.

FOOD AND NON-FOOD CONTACT SURFACES PROPERLY DESIGNED, CONSTRUCTED AND MAINTAINED - Comments: INSTALL SPLASH GUARD ON EXPOSED SINK NEXT TO PREP SINK IN BASEMENT PREP AREA.

Unapproved processes may lack critical safety controls.

Variance required before conducting specialized food processes.

Submit application to CDPH; Include HACCP plan; Await approval before starting; Maintain all required records.

FOOD AND NON-FOOD CONTACT EQUIPMENT UTENSILS CLEAN, FREE OF ABRASIVE DETERGENTS - Comments: CLEAN INTERIOR AND EXTERIOR OF ALL COOLERS, FREEZERS, COOKING EQUIPMENT, PREP TABLES, SHELVING UNITS.

Dirty equipment harbors bacteria and attracts pests.

All equipment and utensils must be clean and properly maintained.

Equipment clean to sight and touch; Free of food debris and grease; Maintained in good repair; Stored properly when clean.

FLOORS: CONSTRUCTED PER CODE, CLEANED, GOOD REPAIR, COVING INSTALLED, DUST-LESS CLEANING METHODS USED - Comments: REPLACE ALL DAMAGED AND MISSING FLOOR TILES IN FRONT PREP, MIDDLE PREP, BASEMENT PREP AND DISHWASHING AREAS. GROUT ALL LOOSE FLOOR TILES IN ALL AREAS. CLEAN FLOORS UNDER ALL EQUIPMENT, ALONG WALLS AND IN ALL CORNERS IN ALL PREP, STORAGE, AND DISHWASHING AREAS.

Damaged floors harbor bacteria and create safety hazards.

Floors must be smooth, cleanable, and maintained.

Smooth, non-porous in food areas; Properly sloped to drains; Coving at wall junctures; Kept clean; Good repair.

WALLS, CEILINGS, ATTACHED EQUIPMENT CONSTRUCTED PER CODE: GOOD REPAIR, SURFACES CLEAN AND DUST-LESS CLEANING METHODS - Comments: REMOVE ALL PEELING PAINT AND HANGING SURFACES INSIDE VENTILATION HOOD IN MIDDLE PREP AREA.

Damaged surfaces cannot be properly cleaned and may harbor pests.

Walls and ceilings must be smooth, cleanable, and in good repair.

Smooth, washable surfaces in food areas; Light colored; No holes or cracks; Clean and maintained.

LIGHTING: REQUIRED MINIMUM FOOT-CANDLES OF LIGHT PROVIDED, FIXTURES SHIELDED - Comments: REPLACE DAMAGED LIGHT SHIELDS IN PIZZA PREP AREA AND MISSING LIGHT SHIELDS IN BASEMENT PREP AREA.

Inadequate lighting prevents detection of contamination and pests.

Adequate protected lighting required in all areas.

50 foot-candles at prep surfaces; 20 foot-candles at 30 inches in storage; Shielded bulbs over exposed food; Clean fixtures.

VENTILATION: ROOMS AND EQUIPMENT VENTED AS REQUIRED: PLUMBING: INSTALLED AND MAINTAINED - Comments: REPAIR LEAKING FAUCET ON 3-COMPARTMENT SINK.

Pests spread numerous diseases through contamination.

No pests or animals allowed in facility.

No evidence of pests; No live animals except service animals; Effective pest control program.

REFRIGERATION AND METAL STEM THERMOMETERS PROVIDED AND CONSPICUOUS - Comments: PROVIDE THERMOMETER IN BASEMENT REACH-IN COOLER AND BEVERAGE COOLER NEAR WASHROOMS.

Poor personal hygiene transfers contaminants to food.

Food handlers must maintain personal cleanliness.

Clean outer clothing; Hair restraints; Short, clean fingernails; No jewelry except plain ring; Clean hands and arms.

PREMISES MAINTAINED FREE OF LITTER, UNNECESSARY ARTICLES, CLEANING EQUIPMENT PROPERLY STORED - Comments: ELEVATE ALL STOCK OFF FLOOR IN PREP AND STORAGE AREAS. STORE MOP HEADS UPRIGHT TO PREVENT INSECT BREEDING.

Contaminated cloths spread bacteria across multiple surfaces.

Wiping cloths must be properly sanitized and stored.

Store in sanitizer between uses (200ppm quat or 50-100ppm chlorine); Separate cloths for food and non-food surfaces; Test sanitizer concentration.

PREMISES MAINTAINED FREE OF LITTER, UNNECESSARY ARTICLES, CLEANING EQUIPMENT PROPERLY STORED - Comments: ELEVATE ALL STOCK OFF FLOOR IN PREP AND STORAGE AREAS. STORE MOP HEADS UPRIGHT TO PREVENT INSECT BREEDING.

Contaminated cloths spread bacteria across multiple surfaces.

Wiping cloths must be properly sanitized and stored.

Store in sanitizer between uses (200ppm quat or 50-100ppm chlorine); Separate cloths for food and non-food surfaces; Test sanitizer concentration.