PINCHED Fails Health Inspection - Chicago Restaurant

CITY OF CHICAGO FOOD SERVICE SANITATION CERTIFICATE - Comments: NOTED PERSON IN CHARGE WITHOUT ORIGINAL CITY OF CHICAGO FOOD SERVICE MANAGER CERTIFICATE ON SITE WHILE PREPARING AND HANDLING TIME AND TEMPERATURE CONTROL FOR SAFETY(TCS) FOODS DURING INSPECTION. PRESENTED SERVSAFE CERT WITH 11/2023 EXAM DATE. INFORMED PERSON IN CHARGE CITY OF CHICAGO ORIGINAL FOOD SERVICE CERTIFICATE MUST REMAIN POSTED ON SITE AND CERTIFIED MANAGER ON SITE DURING TCS FOOD PREP, COOKING, SERVING AND OPERATING HOURS. PRIORITY FOUNDATION VIOLATION #7-38-012. CITATION ISSUED.

Lack of certification indicates potential gaps in food safety knowledge, increasing risk of improper food handling and foodborne illness.

Valid City of Chicago Food Service Sanitation Certificate required and must be posted.

Certificate must be: Current and valid; Posted conspicuously in public view; Held by person in charge during all operating hours; Renewed before expiration date.

FOOD-CONTACT SURFACES: CLEANED & SANITIZED - Comments: OBSERVED HIGH TEMPERATURE WAREWASHING MACHINE NOT MEETING HOT WATER SANITIZER REQUIREMENTS OF AT LEAST 180F FOR THR FINAL RINSE TEMPERATURE. INSTRUCTED TO ONLY USE 3 COMP SINK FOR DISHWASHING NOT TO USE HIGH TEMP WAREWASHING UNIT UNTIL REINSPECTED BY CHICAGO DEPARTMENT OF HEALTH (CDPH). TAGGED UNIT. PRIORITY VIOLATION #7-38-025. CITATION ISSUED.

Dirty equipment harbors and spreads pathogens, causing cross-contamination and illness.

All food contact surfaces must be properly cleaned and sanitized.

Wash, rinse, sanitize after each use; Clean between different raw foods; Every 4 hours for continuous use; When contaminated; Proper procedures and chemicals.

FOOD & NON-FOOD CONTACT SURFACES CLEANABLE, PROPERLY DESIGNED, CONSTRUCTED & USED - Comments: OBSERVED MILK CRATES BEING USED AS SHELVING THROUGHOUT THE PREP AND STORAGE AREAS. MUST REMOVE AND PROVIDE SHELVING THAT IS 6" OFF THE FLOOR AND PROVIDES FLOOR ACCESSIBILITY TO ENSURE ADEQUATE FACILITY CLEANING.

Poor design creates areas that harbor bacteria.

All surfaces must be designed to be easily cleanable.

Smooth, non-porous surfaces; Free of cracks and crevices; Easily disassembled; Accessible for cleaning.

WAREWASHING FACILITIES: INSTALLED, MAINTAINED & USED; TEST STRIPS - Comments: OBSERVED NO IRREVERSIBLE TEST STRIPS/TESTING DEVICE ON SITE TO ADEQUATLY MEASURE THE UTENSIL SURFACE TEMPERATURE (160F) AFTER THE FINAL RINSE FOR HIGH TEMP DISH MACHINE. INSTRUCTED TO PROVIDE. PRIORITY FOUNDATION VIOLATION #7-38-005. NO CITATION ISSUED

Cannot verify sanitization without test strips, risking contaminated equipment.

Warewashing facilities must be properly equipped and supplied.

3-compartment sink or dishwasher; Test strips for sanitizer; Thermometers for water temperature; Adequate drainboards; Proper detergents.

WAREWASHING FACILITIES: INSTALLED, MAINTAINED & USED; TEST STRIPS - Comments: OBSERVED NO CHEMICAL TEST KIT AVAILABLE DURING INSPECTION. INSTRUCTED MANAGER TO PROVIDE CHLORINE TEST KIT FOR PROPER CONCENTRATION IN SANITIZING SOLUTIONS. PRIORITY FOUNDATION 7-38-005 CITATION ISSUED.

Cannot verify sanitization without test strips, risking contaminated equipment.

Warewashing facilities must be properly equipped and supplied.

3-compartment sink or dishwasher; Test strips for sanitizer; Thermometers for water temperature; Adequate drainboards; Proper detergents.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: OBSERVED FACILITY WITH INADEQUATE PLUMBING IN REAR PREP/DISH AREA. CLEAR WATER COMES FROM FLOOR DRAIN LOCATED IN REAR PREP/DISH AREA AT 3 COMP SINK AND WAREWASHING MACHINE: CLEAR WATER POOLS IN REAR PREP/DISH AREA. BUILDING PLUMBER ARRIVED ON SITE COMPLETED RODDING PLUMBING DURING INSPECTION. WATER NO LONGER BACKING UP FROM FLOOR DRAINS. PRIORITY VIOLATION 7-38-030(C). CITATION ISSUED.

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.

ADEQUATE VENTILATION & LIGHTING; DESIGNATED AREAS USED - Comments: OBSERVED BURNED OUT LIGHT BULB IN HOOD VENTILATION SYSTEM, INSTRUCTED TO REPAIR AND MAINTAIN.

Poor ventilation causes condensation and grease buildup; inadequate lighting hides contamination.

Proper ventilation and lighting required throughout.

Ventilation prevents condensation; Adequate lighting for operations; Fixtures shielded; Hoods over cooking equipment.

ADEQUATE VENTILATION & LIGHTING; DESIGNATED AREAS USED - Comments: OBSERVED BURNED OUT LIGHT BULB IN HOOD VENTILATION SYSTEM, INSTRUCTED TO REPAIR AND MAINTAIN.

Poor ventilation causes condensation and grease buildup; inadequate lighting hides contamination.

Proper ventilation and lighting required throughout.

Ventilation prevents condensation; Adequate lighting for operations; Fixtures shielded; Hoods over cooking equipment.