PEPES RESTAURANT Gets Conditional Pass on Health Inspection - Chicago Restaurant

PERSON IN CHARGE PRESENT, DEMONSTRATES KNOWLEDGE, AND PERFORMS DUTIES - Comments: PIC DOESN'T HAVE FOOD MANAGERS CERTIFICATE.MUST PROVIDE AND MAINTAIN.(PRIORITY FOUNDATION)

Without knowledgeable supervision, critical food safety practices may be overlooked, significantly increasing risk of foodborne illness outbreaks affecting multiple customers.

The person in charge must be present during all hours of operation, hold valid certification, and demonstrate food safety knowledge.

Person in charge must: Be present during all operating hours; Hold valid City of Chicago Food Service Sanitation Certificate; Demonstrate knowledge of foodborne disease prevention, HACCP principles, and Code requirements; Ensure employee compliance with food safety practices.

CITY OF CHICAGO FOOD SERVICE SANITATION CERTIFICATE - Comments: OBSERVED NO CERTIFIED FOOD MANAGER ON DUTY WHILE TCS READY TO EAT FOODS ARE BEING PREPARED,HANDLED AND SERVED SUCH AS (BEANS,RICE,COOKED GROUND BEEF,CHICKEN,ETC)MUST BE ON SITE AT ALL TIMES.FOOD MANAGER ARRIVED ON SITE AT 3:25 P.M.(PRIORITY FOUNDATION 7-38-012)

Lack of certification indicates potential gaps in food safety knowledge, increasing risk of improper food handling and foodborne illness.

Valid City of Chicago Food Service Sanitation Certificate required and must be posted.

Certificate must be: Current and valid; Posted conspicuously in public view; Held by person in charge during all operating hours; Renewed before expiration date.

NO BARE HAND CONTACT WITH RTE FOOD OR A PRE-APPROVED ALTERNATIVE PROCEDURE PROPERLY ALLOWED - Comments: OBSERVED BARE HAND CONTACT BY FEMALE FOOD HANDLER.OBSERVED HER REMOVE SOFT TACO SHELLS FROM GRILL WITH BARE HANDS AND PLACE ON TISSUE PAPER.INSTRUCTED PIC NO BARE HAND CONTACT WITH READY TO EAT FOODS.MUST USE TONGS,TISSUE PAPER OR GLOVES.(COS)(PRIORITY 7-38-010)

Contaminated water spreads waterborne diseases. Insufficient hot water prevents proper sanitization.

Potable water supply must be adequate, protected, and properly heated.

Water from approved public system; Sufficient pressure for all operations; Hot water minimum 120°F at fixtures, 180°F for high-temp dishwashers; Backflow prevention installed; No cross-connections.

CONSUMER ADVISORY PROVIDED FOR RAW/UNDERCOOKED FOOD - Comments: OBSERVED NO CONSUMER ADVISORY DISCLOSURE AND REMINDER ON MENU OF CONSUMING RAW AND UNDERCOOKED FOODS.MUST PROVIDE AND MAINTAIN.(PRIORITY FOUNDATION)

Dirty surfaces attract pests and can contaminate food indirectly.

Non-food contact surfaces must be kept clean.

Clean as often as necessary; Remove grease and debris; Maintain equipment exteriors; Keep walls, ceilings, floors clean.

WIPING CLOTHS: PROPERLY USED & STORED - Comments: MUST STORE WIPING CLOTHS IN A SANITIZING SOLUTION WHEN NOT IN USE.

Contaminated cloths spread bacteria across multiple surfaces.

Wiping cloths must be properly sanitized and stored.

Store in sanitizer between uses (200ppm quat or 50-100ppm chlorine); Separate cloths for food and non-food surfaces; Test sanitizer concentration.

GLOVES USED PROPERLY - Comments: INSTRUCTED EMPLOYEE TO USE GLOVES OR A BARRIER TO HANDLE TCS READY TO EAT FOODS.

Improper glove use spreads contamination worse than bare hands.

Single-use gloves must be used correctly.

Wash hands before donning; Change when contaminated; Change between tasks; Single use only; Not a substitute for handwashing.

FOOD & NON-FOOD CONTACT SURFACES CLEANABLE, PROPERLY DESIGNED, CONSTRUCTED & USED - Comments: MUST REMOVE CARD BOARD AND RUST FROM LOWER SHELVES OF GRILL AND PREP TABLES.

Poor design creates areas that harbor bacteria.

All surfaces must be designed to be easily cleanable.

Smooth, non-porous surfaces; Free of cracks and crevices; Easily disassembled; Accessible for cleaning.

FOOD & NON-FOOD CONTACT SURFACES CLEANABLE, PROPERLY DESIGNED, CONSTRUCTED & USED - Comments: MUST REMOVE CARD BOARD AND RUST FROM LOWER SHELVES OF GRILL AND PREP TABLES.

Poor design creates areas that harbor bacteria.

All surfaces must be designed to be easily cleanable.

Smooth, non-porous surfaces; Free of cracks and crevices; Easily disassembled; Accessible for cleaning.