PEACE INFANTS AND TODDLER CENTER Gets Conditional Pass on Health Inspection - Chicago Children's services facility

MANAGEMENT, FOOD EMPLOYEE AND CONDITIONAL EMPLOYEE; KNOWLEDGE, RESPONSIBILITIES AND REPORTING - Comments: 2-102.14(A)-OBSERVED NO EMPLOYEE HEALTH POLICY ON SITE. MUST PROVIDE PRIORITY FOUNDATION VIOLATION#: 7-38-012(A) NO CITATION ISSUED.

Ill food workers cause 70% of foodborne outbreaks. Proper reporting prevents transmission of Norovirus, Hepatitis A, Salmonella, and other serious diseases.

All food employees must understand and follow health reporting requirements and food safety responsibilities.

Employees must: Report illness symptoms and exposures; Be excluded/restricted when ill; Understand their role in preventing foodborne illness; Follow proper hygiene practices; Have signed health policy on file.

PROCEDURES FOR RESPONDING TO VOMITING AND DIARRHEAL EVENTS - Comments: 2-501.11 OBSERVED NO VOMITING AND DIARRHEAL INCIDENT CLEAN UP POLICY IN PLACE AND KIT ON SITE. MUST PROVIDE. PRIORITY FOUNDATION VIOLATION. 7-38-005. NO CITATION ISSUED

Vomit and diarrhea contain millions of viral particles. One incident can contaminate entire facility and cause outbreak affecting dozens.

Written procedures required for cleaning bodily fluid events to prevent disease transmission.

Written procedure must address: Isolating contaminated area; Removing and discarding affected food; Using proper PPE; Cleaning and sanitizing with appropriate concentration; Proper disposal of contaminated materials.

PROPER DATE MARKING AND DISPOSITION - Comments: 3-501.17 (A) OBSERVED PREPARED FOODS NOT PROPERLY LABELED AND DATE MARKED. INSTRUCTED TO PROPERLY LABEL ALL PREPARED FOODS WITH A 7 DAY USE/DISCARD DAY. PRIORITY FOUNDATION VIOLATION:7-38-005. NO CITATION ISSUED.

Inadequate reheating fails to kill bacteria that grew during storage.

Foods must be reheated to 165°F within 2 hours.

Reheat to 165°F within 2 hours; Use proper equipment (not hot holding units); Discard if not reaching temperature in time.

THERMOMETERS PROVIDED & ACCURATE - Comments: 4-203.11 A COOKING THERMOMETER(MEAT) PROVIDED ON SITE.INSTRUCTED TO PROVIDE A STEM THERMOMETER TO BE ABLE TO CHECK FOOD TEMPERATURE(HOT/COLD) PRIORITY FOUNDATION VIOLATION:7-38-005 NO CITATION ISSUED

Inadequate lighting prevents detection of contamination and pests.

Adequate protected lighting required in all areas.

50 foot-candles at prep surfaces; 20 foot-candles at 30 inches in storage; Shielded bulbs over exposed food; Clean fixtures.

CONTAMINATION PREVENTED DURING FOOD PREPARATION, STORAGE & DISPLAY - Comments: NO SPLASH GUARD PROVIDED BETWEEN THE HAND WASHING SINK AND COUNTER TOP WITH CUTTING BOARD STORED ON IT.SURFACE MUST BE SMOOTH CLEANABLE AND NON-ABSORBENT SURFACE

Contamination during preparation is a leading cause of foodborne illness.

Prevent contamination during all food handling.

Minimize bare hand contact; Prevent cross-contamination; Use clean equipment; Proper employee hygiene.

IN-USE UTENSILS: PROPERLY STORED - Comments: 3-304.12-PLASTIC UTENSILS AND UTENSILS USED FOR CHILDREN IMPROPERLY STORED,MUST INVERT SAID UTENSILS

Improper storage contaminates utensils between uses.

In-use utensils must be properly stored between uses.

Store in food with handle out; On clean surface; In running water; In water at 135°F or above.

FOOD & NON-FOOD CONTACT SURFACES CLEANABLE, PROPERLY DESIGNED, CONSTRUCTED & USED - Comments: 4-101.19 BROKEN WRAP AND EXPOSED INSULATION WRAP AROUND PIPES UNDER THE EXPOSED HAND SINK IN THE KITCHEN MUST BE REPLACE.SURFACE MUST BE SMOOTH,CLEANABLE AND NON ABSORBENT SURFACE.NO ROUGH SURFACE

Poor design creates areas that harbor bacteria.

All surfaces must be designed to be easily cleanable.

Smooth, non-porous surfaces; Free of cracks and crevices; Easily disassembled; Accessible for cleaning.

FOOD & NON-FOOD CONTACT SURFACES CLEANABLE, PROPERLY DESIGNED, CONSTRUCTED & USED - Comments: 4-101.19 BROKEN WRAP AND EXPOSED INSULATION WRAP AROUND PIPES UNDER THE EXPOSED HAND SINK IN THE KITCHEN MUST BE REPLACE.SURFACE MUST BE SMOOTH,CLEANABLE AND NON ABSORBENT SURFACE.NO ROUGH SURFACE

Poor design creates areas that harbor bacteria.

All surfaces must be designed to be easily cleanable.

Smooth, non-porous surfaces; Free of cracks and crevices; Easily disassembled; Accessible for cleaning.