ILLINOIS CENTER FOR REHABILITATION AND EDUCATION-R Passes Health Inspection - Chicago Restaurant

ADEQUATE HANDWASHING SINKS PROPERLY SUPPLIED AND ACCESSIBLE - Comments: FOUND NO HANDWASHING SIGNAGE AT ANY HANDWASHING SINKS THROUGHOUT THE FACILITY. HANDWASHING SIGNAGE MUST BE POSTED AT ALL HANDWASHING SINKS AT ALL TIMES.

Blocked or unsupplied sinks force employees to skip handwashing, spreading fecal bacteria and viruses to food.

Handwashing sinks must be accessible, properly supplied, and used only for handwashing.

Each sink needs: Warm water (100°F minimum); Soap in dispensers; Paper towels or air dryers; Waste receptacles; Signage; Clear access; Used only for handwashing.

FOOD-CONTACT SURFACES: CLEANED & SANITIZED - Comments: FOUND TOP INTERIOR OF ICE MACHINE FILLED WITH A YELLOW UNKNOWN SUBSTANCE. INSTRUCTED MANAGER TO CLEAN SANITIZE AND MAINTAIN.

Dirty equipment harbors and spreads pathogens, causing cross-contamination and illness.

All food contact surfaces must be properly cleaned and sanitized.

Wash, rinse, sanitize after each use; Clean between different raw foods; Every 4 hours for continuous use; When contaminated; Proper procedures and chemicals.

THERMOMETERS PROVIDED & ACCURATE - Comments: FOUND NO THERMOMETERS INSIDE ANY REACH COOLERS ON SITE. IN A MECHANICALLY REFRIGERATED OR HOT FOOD STORAGE UNIT, THE SENSOR OF A TEMPERATURE MEASURING DEVICE SHALL BE LOCATED TO MEASURE THE AIR TEMPERATURE OR A SIMULATED PRODUCT TEMPERATURE IN THE WARMEST PART OF A MECHANICALLY REFRIGERATED UNIT AND THE COOLEST PART OF A HOT FOOD STORAGE UNIT. INSTRUCTED TO PROVIDE.

Inadequate lighting prevents detection of contamination and pests.

Adequate protected lighting required in all areas.

50 foot-candles at prep surfaces; 20 foot-candles at 30 inches in storage; Shielded bulbs over exposed food; Clean fixtures.

THERMOMETERS PROVIDED & ACCURATE - Comments: FOUND NO THERMOMETERS INSIDE ANY REACH COOLERS ON SITE. IN A MECHANICALLY REFRIGERATED OR HOT FOOD STORAGE UNIT, THE SENSOR OF A TEMPERATURE MEASURING DEVICE SHALL BE LOCATED TO MEASURE THE AIR TEMPERATURE OR A SIMULATED PRODUCT TEMPERATURE IN THE WARMEST PART OF A MECHANICALLY REFRIGERATED UNIT AND THE COOLEST PART OF A HOT FOOD STORAGE UNIT. INSTRUCTED TO PROVIDE.

Inadequate lighting prevents detection of contamination and pests.

Adequate protected lighting required in all areas.

50 foot-candles at prep surfaces; 20 foot-candles at 30 inches in storage; Shielded bulbs over exposed food; Clean fixtures.