GIORDANO'S OF BEVERLY Gets Conditional Pass on Health Inspection - Chicago Restaurant

SANITIZING RINSE FOR EQUIPMENT AND UTENSILS: CLEAN, PROPER TEMPERATURE, CONCENTRATION, EXPOSURE TIME - Comments: Equipment and utensils should get proper exposure to the sanitizing solution during the rinse cycle. Bactericidal treatment shall consist of exposure of all dish and utensil surfaces to a rinse of clean water at a temperature of not less than 180F.NO SANITIZER SOLUTION DURING THE RINSE CYCLE AND NO SANITIZER 0 PPM ON THE PREMISES OR MINE TEST STRIPS (BOTH USED TEST STRIPS) AT THIS TIME OF INSPECTION. DISH MACHINE TAGGED MUST BE ABLE TO SANITIZE DISHES AT 100PPM. NEED TO USE THE 3 COMPARTMENT SINK TO WASH, RINSE AND SANITIZE ALL UTENSILS, DISHES.

Improper sanitization fails to kill pathogens, allowing contaminated equipment to spread illness throughout facility.

Sanitizing solutions and rinse water must meet specific requirements for effectiveness.

Chemical sanitizers: Chlorine 50-100 ppm, Quaternary ammonium 200-400 ppm, Iodine 12.5-25 ppm; Hot water: 171°F for 30 seconds or 180°F at dish surface; Test strips required; Proper contact time.

FOOD AND NON-FOOD CONTACT SURFACES PROPERLY DESIGNED, CONSTRUCTED AND MAINTAINED - Comments: All food and non-food contact equipment and utensils shall be smooth, easily cleanable, and durable, and shall be in good repair.REMOVE CARDBOARD FROM REAR 2 DOOR FREEZER STORAGE SHELVES.

Unapproved processes may lack critical safety controls.

Variance required before conducting specialized food processes.

Submit application to CDPH; Include HACCP plan; Await approval before starting; Maintain all required records.

FOOD AND NON-FOOD CONTACT EQUIPMENT UTENSILS CLEAN, FREE OF ABRASIVE DETERGENTS - Comments: All food and non-food contact surfaces of equipment and all food storage utensils shall be thoroughly cleaned and sanitized daily.CLEAN AND SANITIZE SLICER AND DEFROST SMALL BOX FREEZER ON COUNTER.

Dirty equipment harbors bacteria and attracts pests.

All equipment and utensils must be clean and properly maintained.

Equipment clean to sight and touch; Free of food debris and grease; Maintained in good repair; Stored properly when clean.

WALLS, CEILINGS, ATTACHED EQUIPMENT CONSTRUCTED PER CODE: GOOD REPAIR, SURFACES CLEAN AND DUST-LESS CLEANING METHODS - Comments: The walls and ceilings shall be in good repair and easily cleaned. CEILING TILE MISSING REAR BETWEEN ICE MACHINE AND 2 COMP. PREP SINK NEED TO REPLACE MISSING TILE.

Damaged surfaces cannot be properly cleaned and may harbor pests.

Walls and ceilings must be smooth, cleanable, and in good repair.

Smooth, washable surfaces in food areas; Light colored; No holes or cracks; Clean and maintained.

LIGHTING: REQUIRED MINIMUM FOOT-CANDLES OF LIGHT PROVIDED, FIXTURES SHIELDED - Comments: Shielding to protect against broken glass falling into food shall be provided for all artificial lighting sources in preparation, service, and display facilities.CLEAN LIGHT SHIELD OUTSIDE THE WALK-IN COOLER.

Inadequate lighting prevents detection of contamination and pests.

Adequate protected lighting required in all areas.

50 foot-candles at prep surfaces; 20 foot-candles at 30 inches in storage; Shielded bulbs over exposed food; Clean fixtures.

LIGHTING: REQUIRED MINIMUM FOOT-CANDLES OF LIGHT PROVIDED, FIXTURES SHIELDED - Comments: Shielding to protect against broken glass falling into food shall be provided for all artificial lighting sources in preparation, service, and display facilities.CLEAN LIGHT SHIELD OUTSIDE THE WALK-IN COOLER.

Inadequate lighting prevents detection of contamination and pests.

Adequate protected lighting required in all areas.

50 foot-candles at prep surfaces; 20 foot-candles at 30 inches in storage; Shielded bulbs over exposed food; Clean fixtures.