EL ALEGRE BURRITO Gets Conditional Pass on Health Inspection - Chicago Restaurant

SANITIZING RINSE FOR EQUIPMENT AND UTENSILS: CLEAN, PROPER TEMPERATURE, CONCENTRATION, EXPOSURE TIME - Comments: Equipment and utensils should get proper exposure to the sanitizing solution during the rinse cycle. Bactericidal treatment shall consist of exposure of all dish and utensil surfaces to a rinse of clean water at a temperature of not less than 180F. FOUND NO SANITIZER AT THE RINSE COMPARTMENT OF THE 3 COMPARTMENT SINK. EMPLOYEES WASHING MULTI-USE UTENSILS AT IMPROPER SET-UP. INTRUCTED TO WASH, RINSE AND SANITIZE PROPERLY WITH 100 PPM (CHLORINE CONCENTRATION). MUST ALSO PROVIDE SANITIZING TEST STRIPS (CHLORINE). CRITICAL CITATION ISSUED (7-38-030)

Improper sanitization fails to kill pathogens, allowing contaminated equipment to spread illness throughout facility.

Sanitizing solutions and rinse water must meet specific requirements for effectiveness.

Chemical sanitizers: Chlorine 50-100 ppm, Quaternary ammonium 200-400 ppm, Iodine 12.5-25 ppm; Hot water: 171°F for 30 seconds or 180°F at dish surface; Test strips required; Proper contact time.

WATER SOURCE: SAFE, HOT & COLD UNDER CITY PRESSURE - Comments: All food establishments shall be provided with an adequate supply of hot and cold water under pressure properly connected to the city water supply. FOUND NO HOT RUNNING WATER THROUGHOUT PREMISES. INSTRUCTED TO PROVIDE. AFTER 20 MINUTES HOT WATER WAS REPLENISHED. RECOMMEND TO PROVIDE LARGER HOT WATER TANK. CRITICAL CITATION ISSUED (7-38-030)

Contaminated water spreads waterborne diseases. Insufficient hot water prevents proper sanitization.

Potable water supply must be adequate, protected, and properly heated.

Water from approved public system; Sufficient pressure for all operations; Hot water minimum 120°F at fixtures, 180°F for high-temp dishwashers; Backflow prevention installed; No cross-connections.

FOOD AND NON-FOOD CONTACT SURFACES PROPERLY DESIGNED, CONSTRUCTED AND MAINTAINED - Comments: All food and non-food contact equipment and utensils shall be smooth, easily cleanable, and durable, and shall be in good repair. INSTRUCTED TO REMOVE OLD/LOOSE CAULKING AROUND EXPOSED HAND SINK IN REAR PREP AND RECAULK.

Unapproved processes may lack critical safety controls.

Variance required before conducting specialized food processes.

Submit application to CDPH; Include HACCP plan; Await approval before starting; Maintain all required records.

FOOD AND NON-FOOD CONTACT SURFACES PROPERLY DESIGNED, CONSTRUCTED AND MAINTAINED - Comments: All food and non-food contact equipment and utensils shall be smooth, easily cleanable, and durable, and shall be in good repair. INSTRUCTED TO REMOVE OLD/LOOSE CAULKING AROUND EXPOSED HAND SINK IN REAR PREP AND RECAULK.

Unapproved processes may lack critical safety controls.

Variance required before conducting specialized food processes.

Submit application to CDPH; Include HACCP plan; Await approval before starting; Maintain all required records.