DEPASADA RESTAURANT Gets Conditional Pass on Health Inspection - Chicago Restaurant

MANAGEMENT, FOOD EMPLOYEE AND CONDITIONAL EMPLOYEE; KNOWLEDGE, RESPONSIBILITIES AND REPORTING - Comments: NO WRITTEN EMPLOYEE HEALTH POLICY PROVIDED ON THE PREMISES. INSTRUCTED TO HAVE A SIGNED EMPLOYEE HEALTH POLICY FOR EACH EMPLOYEE. PRIORITY FOUNDATION 7-38-010. NO CITATION ISSUED.

Ill food workers cause 70% of foodborne outbreaks. Proper reporting prevents transmission of Norovirus, Hepatitis A, Salmonella, and other serious diseases.

All food employees must understand and follow health reporting requirements and food safety responsibilities.

Employees must: Report illness symptoms and exposures; Be excluded/restricted when ill; Understand their role in preventing foodborne illness; Follow proper hygiene practices; Have signed health policy on file.

PROCEDURES FOR RESPONDING TO VOMITING AND DIARRHEAL EVENTS - Comments: 2-501.11 NO CLEAN-UP PROCEDURE ON PREMISES FOR VOMIT AND DIARRHEAL EVENTS. MANAGEMENT INSTRUCTED TO PROVIDE A CLEAN-UP PROCEDURE AND SUPPLIES. PRIORITY FOUNDATION 7-38-005. NO CITATION ISSUED.

Vomit and diarrhea contain millions of viral particles. One incident can contaminate entire facility and cause outbreak affecting dozens.

Written procedures required for cleaning bodily fluid events to prevent disease transmission.

Written procedure must address: Isolating contaminated area; Removing and discarding affected food; Using proper PPE; Cleaning and sanitizing with appropriate concentration; Proper disposal of contaminated materials.

PROPER DATE MARKING AND DISPOSITION - Comments: MUST PROVIDE DATE MARKINGS ON ALL RTE FOODS STORED IN COOLERS THAT ARE HELD OVER 24 HOURS. INSTRUCTED TO MAINTAIN. PRIORITY FOUNDATION 7-38-005 NO CITATION ISSUED

Inadequate reheating fails to kill bacteria that grew during storage.

Foods must be reheated to 165°F within 2 hours.

Reheat to 165°F within 2 hours; Use proper equipment (not hot holding units); Discard if not reaching temperature in time.

THERMOMETERS PROVIDED & ACCURATE - Comments: ALL REACH IN COOLERS MUST HAVE THERMOMETERS VISIBLE AT ALL TIMES. CORRECT AND MAINTAIN.

Inadequate lighting prevents detection of contamination and pests.

Adequate protected lighting required in all areas.

50 foot-candles at prep surfaces; 20 foot-candles at 30 inches in storage; Shielded bulbs over exposed food; Clean fixtures.

WIPING CLOTHS: PROPERLY USED & STORED - Comments: ALL WIPING CLOTHS MUST BE KEPT IN A CLEAN SANITIZING SOLUTION WHEN NOT IN USE. CORRECT AND MAINTAIN.

Contaminated cloths spread bacteria across multiple surfaces.

Wiping cloths must be properly sanitized and stored.

Store in sanitizer between uses (200ppm quat or 50-100ppm chlorine); Separate cloths for food and non-food surfaces; Test sanitizer concentration.

FOOD & NON-FOOD CONTACT SURFACES CLEANABLE, PROPERLY DESIGNED, CONSTRUCTED & USED - Comments: CUTTING BOARDS ARE DARK IN COLOR WITH DEEP CUTS. MUST REPAIR OR REPLACE.

Poor design creates areas that harbor bacteria.

All surfaces must be designed to be easily cleanable.

Smooth, non-porous surfaces; Free of cracks and crevices; Easily disassembled; Accessible for cleaning.

NON-FOOD/FOOD CONTACT SURFACES CLEAN - Comments: COOKING EQUIPMENT IN NEED OF CLEANING TO REMOVE ALL FOOD SPILLS AND BUILD UP. CLEAN AND MAINTAIN.

Accumulated soil attracts pests and harbors bacteria.

All surfaces must be kept clean.

Clean equipment interiors and exteriors; Walls, ceilings, floors clean; Remove grease and debris; Clean as often as necessary.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: FAUCET ON THE HANDSINK IN NEED OF REPAIRING. LOOSE CORRECT AND MAINTAIN.

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: FAUCET ON THE HANDSINK IN NEED OF REPAIRING. LOOSE CORRECT AND MAINTAIN.

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.