COMFORT AFRICAN CUISINE Fails Health Inspection - Chicago Restaurant

MANAGEMENT, FOOD EMPLOYEE AND CONDITIONAL EMPLOYEE; KNOWLEDGE, RESPONSIBILITIES AND REPORTING - Comments: NO EMPLOYEE HEALTH POLICY/TRAINING ON SITE. INSTRUCTED FACILITY TO ESTABLISH AN APPROPRIATE EMPLOYEE HEALTH POLICY/TRAINING SYSTEM AND MAINTAIN WITH VERIFIABLE DOCUMENTS ON SITE. PRIORITY FOUNDATION VIOLATION 7-38-010.

Ill food workers cause 70% of foodborne outbreaks. Proper reporting prevents transmission of Norovirus, Hepatitis A, Salmonella, and other serious diseases.

All food employees must understand and follow health reporting requirements and food safety responsibilities.

Employees must: Report illness symptoms and exposures; Be excluded/restricted when ill; Understand their role in preventing foodborne illness; Follow proper hygiene practices; Have signed health policy on file.

PROCEDURES FOR RESPONDING TO VOMITING AND DIARRHEAL EVENTS - Comments: NO PROCEDURE/PLAN AND KIT FOR RESPONDING TO VOMITING AND DIARRHEAL EVENTS. INSTRUCTED FACILITY TO DEVELOP AND MAINTAIN A PROCEDURE/PLAN AND TO MAINTAIN ANY APPROPRIATE SUPPLIES ON SITE. PRIORITY FOUNDATION VIOLATION 7-38-005.

Vomit and diarrhea contain millions of viral particles. One incident can contaminate entire facility and cause outbreak affecting dozens.

Written procedures required for cleaning bodily fluid events to prevent disease transmission.

Written procedure must address: Isolating contaminated area; Removing and discarding affected food; Using proper PPE; Cleaning and sanitizing with appropriate concentration; Proper disposal of contaminated materials.

PROPER COOLING METHODS USED; ADEQUATE EQUIPMENT FOR TEMPERATURE CONTROL - Comments: BOTH TWO DOOR REACH-IN COOLERS MAINTAINS AIR TEMP OF 50F AND ABOVE. MUST MAINTAIN TEMP OF 41F AND BELOW. PRIORITY VIOLATION:7-38-005

Dirty equipment harbors bacteria and attracts pests.

All equipment and utensils must be clean and properly maintained.

Equipment clean to sight and touch; Free of food debris and grease; Maintained in good repair; Stored properly when clean.

THERMOMETERS PROVIDED & ACCURATE - Comments: THERMOMETER IS NEEDED INSIDE THE COOLERS

Inadequate lighting prevents detection of contamination and pests.

Adequate protected lighting required in all areas.

50 foot-candles at prep surfaces; 20 foot-candles at 30 inches in storage; Shielded bulbs over exposed food; Clean fixtures.

THERMOMETERS PROVIDED & ACCURATE - Comments: NO STEM THERMOMETER PROVIDED ON SITE TO BE ABLE TO CHECK FOOD TEMPERATURE, INSTRUCTED TO PROVIDE. PRIORITY FOUNDATION VIOLATION:7-38-005

Inadequate lighting prevents detection of contamination and pests.

Adequate protected lighting required in all areas.

50 foot-candles at prep surfaces; 20 foot-candles at 30 inches in storage; Shielded bulbs over exposed food; Clean fixtures.

WAREWASHING FACILITIES: INSTALLED, MAINTAINED & USED; TEST STRIPS - Comments: OBSERVED BAR THREE COMPARTMENT SINK INSTALLED AT REAR DISHROOM/PREP AREA.NOT LARGE ENOUGH FOR OVER-SIZED UTENSILS(POTS). MUST INSTALL A LARGER 3 COMPARTMENT TO BE ABLE TO SUBMERGE THE LARGEST UTENSIL/POTS. PRIORITY FOUNDATION VIOLATION:7-38-025.

Cannot verify sanitization without test strips, risking contaminated equipment.

Warewashing facilities must be properly equipped and supplied.

3-compartment sink or dishwasher; Test strips for sanitizer; Thermometers for water temperature; Adequate drainboards; Proper detergents.

WAREWASHING FACILITIES: INSTALLED, MAINTAINED & USED; TEST STRIPS - Comments: A DRAIN BOARD IS REQUIRED AT THREE COMPARTMENT SINK FOR HOLDING CLEANED UTENSIL AFTER SANITIZING AT BAR AREA.

Cannot verify sanitization without test strips, risking contaminated equipment.

Warewashing facilities must be properly equipped and supplied.

3-compartment sink or dishwasher; Test strips for sanitizer; Thermometers for water temperature; Adequate drainboards; Proper detergents.

WAREWASHING FACILITIES: INSTALLED, MAINTAINED & USED; TEST STRIPS - Comments: LOW TEMP DISHMACHINE NOT IN WORKING CONDITION UNABLE TO FILL UNIT.INSTRUCTED TO REPAIR ISSUE. FRIORITY FOUNDATION VIOLATION:7-38-025

Cannot verify sanitization without test strips, risking contaminated equipment.

Warewashing facilities must be properly equipped and supplied.

3-compartment sink or dishwasher; Test strips for sanitizer; Thermometers for water temperature; Adequate drainboards; Proper detergents.

HOT & COLD WATER AVAILABLE; ADEQUATE PRESSURE - Comments: HOT WATER ON SITE HOWEVER NOT ABLE TO MAINTAIN MINIMUM OF 100F AT WASHROOMS(68F TO 93.9F); HANDWASHING SINK 87F TO 93.4F. THREE COMPARTMENT SINK 94.7F,MUST MAINTAIN TEMP OF 110F. REPAIR ISSUE AND PROVIDE HOT WATER ACCORDINGLY. PRIORITY FOUNDATION VIOLATION:7-38-005

Without proper water temperatures, cannot sanitize or clean properly.

Adequate hot and cold running water required.

Hot water 120°F minimum at fixtures; Cold water available; Sufficient pressure; From approved source.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: NO BACK FLOW PREVENTION DEVICE PROVIDED AT ICE MACHINE WATER LINE,AT LOCATED AT SECOND FLOOR. ALSO PROVIDE A BACK FLOW PREVENTION DEVICE AT MOP SINK. MUST INSTALL SO BACK FLOW PREVENTION DEVICE MAY BE LOCATED TO BE SERVICED AND MAINTAIN.

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: OBSERVED SINK STOPPERS ARE NEEDED AT 3 COMPARTMENT SINK. -

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: OBSERVED SINK STOPPERS ARE NEEDED AT 3 COMPARTMENT SINK. -

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.