COFFEE SHOP Fails Health Inspection - Chicago Restaurant

PROCEDURES FOR RESPONDING TO VOMITING AND DIARRHEAL EVENTS - Comments: NO VOMIT AND DIARRHEA CLEAN-UP PROCEDURE ON-PREMISES. INSTRUCTED MUST PROVIDE A VOMIT AND DIARRHEA CLEAN-UP PROCEDURE WITH ALL NECESSARY ITEMS OUTLINED IN POLICY ON-PREMISES. PRIORITY FOUNDATION 7-38-005.

Vomit and diarrhea contain millions of viral particles. One incident can contaminate entire facility and cause outbreak affecting dozens.

Written procedures required for cleaning bodily fluid events to prevent disease transmission.

Written procedure must address: Isolating contaminated area; Removing and discarding affected food; Using proper PPE; Cleaning and sanitizing with appropriate concentration; Proper disposal of contaminated materials.

ADEQUATE HANDWASHING SINKS PROPERLY SUPPLIED AND ACCESSIBLE - Comments: NO HANDWASH SINK IN THE PREP AREA. INSTRUCTED MANAGER MUST PROVIDE A HANDWASH SINK WITH RUNNING HOT AND COLD WATER IN THE PREP AREA. PRIORITY FOUNDATION 7-38-030(C).

Blocked or unsupplied sinks force employees to skip handwashing, spreading fecal bacteria and viruses to food.

Handwashing sinks must be accessible, properly supplied, and used only for handwashing.

Each sink needs: Warm water (100°F minimum); Soap in dispensers; Paper towels or air dryers; Waste receptacles; Signage; Clear access; Used only for handwashing.

PROPER COOLING METHODS USED; ADEQUATE EQUIPMENT FOR TEMPERATURE CONTROL - Comments: ALL COOLERS AND FREEZERS ARE OFF AT THIS TIME. INSTRUCTED ALL COOLERS AND FREEZERS MUST BE TURNED ON WITH COOLERS AMBIENT AIR TEMPERATURE AT 41.0 F OR BELOW AND FREEZERS FROZEN. PRIORITY VIOLATION 7-38-005.

Dirty equipment harbors bacteria and attracts pests.

All equipment and utensils must be clean and properly maintained.

Equipment clean to sight and touch; Free of food debris and grease; Maintained in good repair; Stored properly when clean.

THERMOMETERS PROVIDED & ACCURATE - Comments: NO METAL STEM FOOD THERMOMETER ON-PREMISES. INSTRUCTED MUST PROVIDE AND CALIBRATE A METAL STEM FOOD THERMOMETER ON-PREMISES. PRIORITY FOUNDATION 7-38-005.

Inadequate lighting prevents detection of contamination and pests.

Adequate protected lighting required in all areas.

50 foot-candles at prep surfaces; 20 foot-candles at 30 inches in storage; Shielded bulbs over exposed food; Clean fixtures.

INSECTS, RODENTS, & ANIMALS NOT PRESENT - Comments: NO PEST CONTROL LOGBOOK ON-PREMISES. INSTRUCTED MUST PROVIDE A PEST CONTROL LOGBOOK FROM A LICENSED ILLINOIS PEST CONTROL OPERATOR ON PREMISES. PRIORITY FOUNDATION 7-38-020(C).

Pests spread numerous diseases through contamination.

No pests or animals allowed in facility.

No evidence of pests; No live animals except service animals; Effective pest control program.

CONTAMINATION PREVENTED DURING FOOD PREPARATION, STORAGE & DISPLAY - Comments: NO SPLASH GUARD BETWEEN DISHWASHER HANDWASH SINK AND THE 3-COMPARTMENT SINK. MUST PROVIDE.

Contamination during preparation is a leading cause of foodborne illness.

Prevent contamination during all food handling.

Minimize bare hand contact; Prevent cross-contamination; Use clean equipment; Proper employee hygiene.

WAREWASHING FACILITIES: INSTALLED, MAINTAINED & USED; TEST STRIPS - Comments: NO SANITIZING TEST STRIPS ON PREMISES. MUST PROVIDE. PRIORITY FOUNDATION 7-38-005.

Cannot verify sanitization without test strips, risking contaminated equipment.

Warewashing facilities must be properly equipped and supplied.

3-compartment sink or dishwasher; Test strips for sanitizer; Thermometers for water temperature; Adequate drainboards; Proper detergents.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: BACKFLOW PREVENTION DEVICE NOT LOCATED ON MOP SINK. MUST PROVIDE AND MAKE VISIBLE A BACKFLOW PREVENTION DEVICE FOR THE MOP SINK.

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.

PLUMBING INSTALLED; PROPER BACKFLOW DEVICES - Comments: BACKFLOW PREVENTION DEVICE NOT LOCATED ON MOP SINK. MUST PROVIDE AND MAKE VISIBLE A BACKFLOW PREVENTION DEVICE FOR THE MOP SINK.

Backflow can contaminate entire water supply with sewage or chemicals.

Plumbing must be properly installed with backflow prevention.

Air gaps at fixtures; Backflow preventers on connections; No cross-connections; Annual testing of devices; Proper drainage.